Soccer Pennant Banner DIY Guide

If you are looking for the DIY strategy to make a custom football pennant, happen to be on the right page. Ideally, the full process are going to be easier if you utilize a real pennant like a guide. This will make it easier for you to find the measurements. So, why don’t we get started and have the practical aspect on the project.

As said earlier, be sure you get an actual product for assistance. For instance, you can aquire one yard of felt at the same time. Next, you are able to free-hand the amount cutting. Ideally, it is possible to cut one number a little smaller than the last number for any layered look. Actually, the reasoning is to guarantee the numbers are of the correct size for your pennant. If it is possible to get the shape right, you’ll be able to get the position done in the very first stage. Next, stitching ought to be done.

Also, be sure to sew the most notable and sides of an tall rectangle on the pennant’s left side, which will generate a rod pocket. This rod pocket is going to be used for that dowel.

The dowel rods are certainly not expensive. You can get each bit for less than a buck. So, the purchase price won’t be problems if you are concered about your budget. It’s easier to get a few extra dowel rods in case you create a mistake during the process. You may use the spare dowel rods in cases like this.

You may use a tool being a branch trimmer to take them into two pieces. The one around the extreme right side is designed for your private use. If you are which makes it for your daughter, ensure that you keep the length short. One good thing about shorter dowels is your daughter will keep better control of it.

You must make sure the dowel is secured within the pocket, that’s necessary to stop the dowel from flying towards stands of visitors the very first time it’s waved. Make sure you mark the ending points in the rod pocket. You will use a sharpie marker or finger hold.

Your next step is always to get some duct tape (it needs to be 6″ inches long). Once you have it, you must cut it in two. This will offer you two small pieces. Beginning a tad above the marked point, you ought to wrap the tape around. Next, you must add another piece over it.

Here you need to note that the outer strips often work being a stopper. Therefore, the strip that faces out won’t slide down or up. On one other hand, the inner strip offers just the best amount of grip for the rod pocket. This way you will not lose your pennant. Moreover, the grip must not be so strong that taking out the dowel becomes impossible at the end on the season. After all, you should employ the same pennant next year at the same time.